(Both are PPPOe), Interchange the lines, the routers, the usernames & passwords the result is the same. Both the Routers are Dlink DIR-600 build 15778, On the router using the username & password of Static IP line I get WAN IP but no internet surfing, Now in the same router I put username & password for Dynamic IP line I get WAN IP & internet too. I have two connections from the same ISP, one with dynamic IP and another with Static IP, I can interchange the username & passwords on both the lines and get access (I am the administrator for the DSLAM, hence I can remove the Vmac binding to allow this to happen). ISP to assigbn WAN IP and then do "apply settings" on the advanced routing page after which every thin runs normally, Now please help to sort this issue, IMP:THE APPLY SETTINGS HAD TO BE DONE ONLY AFTER THE ROUTER GETS WAN IP, DOING IT BEFORE THAT HAS NOĮFFECT.Also DDNS DOES NOTfunction as it connects to the server immediately after WAN IP ase NAT DOES not function unless "apply settings" is done" I let the router boot and the ISP assign the WAN IP address after that I go to Advanced Routing page and click on "apply settings" and the NAT automatically starts and clients connected to the router can ping as well as surf (in fact there is no need to run the other two commands also), But the problem is I have to do this everytime I boot the router wait for the But accidently I stumbled upon a very imp discovery. ![]() "the iptables command did not have any effect. ![]() Here is a link to dd-wrt forum which explains the "apply settings" problem:
0 Comments
Leave a Reply. |